High Build Epoxy 195-60 Series
Specialty Coatings 195-60 Series
195-60 Series is a two component 93% (+/- 1%) solids epoxy colored coating designed for applications where a high solids primer is needed prior to applying high solids or 100% solids topcoats for build coats over concrete.
Recommended as a stand alone high build basecoat on concrete or masonry. An ideal product to use as a basecoat for a decorative vinyl chip floor system.
SCI 195-60 is a two component 93% (+/- 1%) solids epoxy colored coating designed for applications where a high solids primer is needed before applying high solids or 100% solids topcoats for build coats over concrete.
RECOMMENDED FOR:
Recommended for a high build basecoat on concrete or masonry. Product is suitable in many chemical exposure environments.
SOLIDS BY WEIGHT:
93% (+/- 1%)
SOLIDS BY VOLUME:
85% (+/-2%)
VOLATILE ORGANIC CONTENT:
Part A= .14#/gallon, part B= 2.1#/gallon
Mixed VOC less than 95 g/l
STANDARD COLORS:
Off white, light gray, medium gray, tile red, beige
OTHER COLORS ALSO AVAILABLE:
Dark gray, charcoal gray, brown, tan, light blue, and green
Special colors are available upon request
RECOMMENDED FILM THICKNESS:
6-12 mils
COVERAGE PER GALLON:
133-267 square feet per gallon @ 6-12 mils
PACKAGING INFORMATION
3 gallon kit (volume approximate) and 15 gallon kits (volume approximate)
MIX RATIO:
12 pounds (1.0 gallon) part A to 3.85 pounds (0.50 gallons) part B (volumes approx.) (standard colors)
SHELF LIFE:
1 year in unopened containers
FINISH CHARACTERISTICS:
Gloss (typical 60 at 60 degrees )
CURE SCHEDULE: (70°)
pot life – 1 1/2 gallon volume ………………………35-55 minutes
tack free (dry to touch)………………...…………..……. 6-9 hours
recoat or topcoat.....………………………………...... 10-14 hours
light foot traffic...…………………………...……...........12-16 hours
full cure (heavy traffic)... ……………………………… 2-7 days
APPLICATION TEMPERATURE:
60-90 degrees F with relative humidity below 85% for best results
PRIMER:
None usually required
TOPCOAT:
Recommend epoxy coatings or high builds. Topcoat with aliphatic urethanes for increased UV stability and as a wear layer over decortative vinyl chip systems.
LIMITATIONS:
*Color stability or gloss may be affected by environmental conditions such as high humidity or chemical exposure.
*Colors may vary from batch to batch.
*This product is not UV color stable but has fairly good color stability, topcoat recommended but optional.
*Substrate temperature must be 5°F above dew point.
*For best results, apply a 1/4” nap roller.
*All new concrete must be cured for at least 30 days prior to application.
*Although a thinner or lower solids primer is generally unnecessary, some more porous substrates may benefit by the use of a lower solid primer, with this product as an intermediate coat.
REFER TO TDS FOR MORE INFORMATION:
