"Silver 600" Floor Kit
Our Hi-Performance, user friendly solvent base system. SGF600
As low as $474.85
Our "Silver" level floor kits are a hi-performance, high solids, solvent based epoxy system designed for ease of application while providing maximum protection and durability. Get creative with your choice of epoxy colors, decorative chips and clear protective urethane that will enhance and customize your garage floor. You will be the envy of your friends and neighbors. This kit include: 2 x 1 gl kit of fast set primer, 2 x 1.5 gls of epoxy, 4 lbs of decorative chips and 1 x 1.5 gl kit of urethane, enough product to coat 600 sq ft.
Hi-performance, heavy duty coatings that provide long lasting professional results at an affordable price.
PROPER PRERATION IS THE KEY TO A LONG LASTING, PROFESSIONAL LOOKING FLOOR JOB.
First things first:
The following is a basic guide only. Prior to any painting, the concrete floor needs to be checked for moisture and the presence of a concrete sealer.
Tape down a 4’x4’ piece of plastic to the floor and allow to remain in place overnight. If beads of water appear on the plastic, there is a potential moisture problem. Coatings will not properly dry and cure with moisture migrating through the concrete.
Check for a concrete sealer. Sprinkle the concrete in a small area with water. If the water remains beaded and does not soak into the concrete within a few minutes, this could indicate the presence of a sealer on the surface. Acid etching will not remove sealers, in this case the concrete must be grinded or shot blasted for the epoxy coating to gain adhesion. Floor grinders can be rented at your local hardware or big box retailer.
If no moisture and concrete sealer is detected, you may proceed to preparing the floor for the epoxy coating.
BARE CONCRETE: The floor must be clean and free from all oils, grease and other contaminants. The use of SCI Liquid Cleaner/Degreaser is recommended to clean to surface following the recommended dilution ratios.
Once the floor is clean, proceed with the etching process. Concrete can be etched with muriatic acid purchased from your local hardware store or SCI Liquid Concrete Etch. Dampen concrete and apply the etching solution with a with a sprinkling can. Pour uniformly onto surface and scrub in with a stiff bristle brush. Wait for approximately 5-10 minutes or until the concrete stops bubbling. Thoroughly rinse surface with pressure nozzle and a bristle broom to remove all traces of the etching product. Check the surface, it should feel roughened similar to an 80 grit sandpaper. If not, repeat the etching process. (We recommend a solution of 1lb of baking soda to 5 gals of water or TSP to insure the surface is neutralized.) Allow surface to thoroughly dry 24-48 hours.
Clean a small area and apply a test patch of the new coating to insure it does not lift existing. Clean surface thoroughly with SCI Liquid Cleaner/Degreaser or equivalent. Glossy surfaces should be dulled by light sanding or abrasive pad on a floor scrubber. Surface must be clean, dry and free of all contaminates prior to painting.